标准资料网-标准资料免费资源平台

Product Code:SAE J2288
Title:Life Cycle Testing of Electric Vehicle Battery Modules
Issuing Committee:Electric Vehicle Forum Committee
Scope: This SAE Recommended Practice defines a standardized test method to determine the expected service life, in cycles, of electric vehicle battery modules. It is based on a set of nominal or baseline operating conditions in order to characterize the expected degradation in electrical performance as a function of life and to identify relevant failure mechanisms where possible. Accelerated aging is not included in the scope of this procedure, although the time compression resulting from continuous testing may unintentionally accelerate battery degradation unless test conditions are carefully controlled. The process used to define a test matrix of accelerated aging conditions based on failure mechanisms, and to establish statistical confidence levels for the results, is considered beyond the scope of this document. Because the intent is to use standard testing conditions whenever possible, results from the evaluation of different technologies should be comparable. End-of-life is determined based on module capacity and power ratings. This may result in a measured cycle life different than that which would be determined based on actual capacity; however, this approach permits a battery manufacturer to make necessary tradeoffs between power and energy in establishing ratings for a battery module. This approach is considered appropriate for a mature design or production battery. It should be noted that the procedure defined in this document is funtionally identicaly to the USABC Baseline Life Cycle Test Procedure.Product Code:SAE AMS4246
Title:Aluminum Alloy, Welding Wire 7.0si 0.52mg (357)
Issuing Committee:Ams D Nonferrous Alloys Committee
Scope:This specification covers an aluminum alloy in the form of welding wire.